# 1.GPIO port

There is no separate GPIO port on BiBoard, but the multiplexed serial port 2 (pin 16, 17) or the PWM pin of the unused PWM servo interface can be used as GPIO port. The GPIO port is also relatively simple to use. After configuring the input and output mode, the usage is exactly the same as that of Arduino UNO. You can use any IO control program of Arduino UNO, just change the number of IO .

```c
/* In this demo, we use TX2, RX2 as general purpose IO
*   TX2 : IO17
*   RX2 : IO16
*/

void setup() {
  // initialize digital pin 16 & 17 as an output.
  pinMode(16, OUTPUT);
  pinMode(17, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
    
  digitalWrite(16, HIGH);            // GPIO 16 & 17 HIGH
  digitalWrite(17, HIGH);
  delay(1000);                       // wait for a second

  digitalWrite(16, LOW);             // GPIO 16 & 17 LOW
  digitalWrite(17, LOW);
  delay(1000);                       // wait for a second
}
```


---

# Agent Instructions: Querying This Documentation

If you need additional information that is not directly available in this page, you can query the documentation dynamically by asking a question.

Perform an HTTP GET request on the current page URL with the `ask` query parameter:

```
GET https://guide.petoi.com/biboard/demo-applications/1.gpio-port.md?ask=<question>
```

The question should be specific, self-contained, and written in natural language.
The response will contain a direct answer to the question and relevant excerpts and sources from the documentation.

Use this mechanism when the answer is not explicitly present in the current page, you need clarification or additional context, or you want to retrieve related documentation sections.